FARGO electronic M10, C10 service manual Replacing the Left Card Sensor Assembly

RESTRICTED USE ONLY Fargo Electronics, Inc.

Replacing the Left Card Sensor Assembly (830135)

Caution: This device is electrostatic sensitive. It may be damaged if exposed to static electrical discharges. (Discharges may be generated by various means, such as walking on a carpeted floor.) Be sure to observe all established Electro-Static Discharge (ESD) procedures while handling cables in or near the Circuit Board and Printhead Assemblies. Always wear an appropriate personal grounding device, such as a wrist strap with integral resistor, connected to an ESD ground to avoid potential damage. At a minimum, make positive contact with the bare metal chassis of the printer with the hand before proceeding with the procedure.

Refer To Drawing 830117-XX. TTR: 15 minutes.

Step	Procedure
1	Unplug the power cord from the printer.
2	Remove the Rear Pivot Cover.
3	Detach the Print Circuit Board from the chassis without the removing wire
	connectors.
4	Remove the Screw (130939) from the Left Card Sensor Assembly (830135).
5	Disconnect the cable connection from J8 on the Print Circuit Board.
6	Attach a string to the cable connector; carefully draw it through the wire path.
7	Take the Left Card Sensor Assembly from the printer. Note: Use the string as
	a means of guiding the new Left Card Sensor Assembly cable through the
	printer.

Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0) 126