RESTRICTED USE ONLY

Fargo Electronics, Inc.

Replacing the Magnetic Head Assembly (High-Coercivity: 83019012

or Low Coercivity: 83019012)

Caution: This device is electrostatic sensitive. It may be damaged if exposed to static electrical discharges. (Discharges may be generated by various means, such as walking on a carpeted floor.) Be sure to observe all established Electro-Static Discharge (ESD) procedures while handling cables in or near the Circuit Board and Printhead Assemblies. Always wear an appropriate personal grounding device, such as a wrist strap with integral resistor, connected to an ESD ground to avoid potential damage. At a minimum, make positive contact with the bare metal chassis of the printer with the hand before proceeding with the procedure.

Refer To Drawing SK1707. TTR: 10 minutes

Step

Procedure

 

 

1

Unplug the power cord form the printer.

 

 

2

Turn the printer upside down.

 

 

3

Remove the two Screws attached to the Bottom Access Plate. Refer to Drawing

 

830171.

 

 

4

Take out the two Screws that secure the Magnetic Head in place.

 

 

5

Move the Magnetic Head out of position.

 

 

6

Set the two Magnetic Head Spacers aside for replacement.

 

 

7

Turn the printer upright.

 

 

8

Take off the Rear Pivot Cover.

 

 

9

Detach the Print Circuit Board fromthe baseplate. Do not remove any wire

 

connectors unless indicated.

 

 

10

Disconnect the cable connector from J18 on the Print Circuit Board.

 

 

11

Place the printer on the input end.

 

 

12

Work the cable connector through the opening to the Access Plate area.

 

 

14

Remove the Magnetic Head Assembly from the printer.

 

 

Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0)

139

 

Page 139
Image 139
FARGO electronic C10, M10 service manual Refer To Drawing SK1707. TTR 10 minutes