RESTRICTED USE ONLY

Fargo Electronics, Inc.

Section 4: Printer Driver Setup

Safety Messages (review carefully)

Symbol

Critical Instructions for Safety purposes

 

 

Danger:

Failure to follow these installation guidelines can result in death or

 

serious injury.

 

Information that raises potential safety issues is indicated by a warning

 

symbol (as shown to the below).

 

To prevent personal injury, refer to the following safety messages

 

before performing an operation preceded by this symbol.

 

To prevent personal injury, always remove the power cord prior to

 

performing repair procedures, unless otherwise specified.

 

To prevent personal injury, make sure only qualified personnel

 

perform these procedures.

 

 

Caution:

This device is electrostatically sensitive. It may be damaged if

 

exposed to static electricity discharges.

 

Information that raises potential electrostatic safety issues is indicated

 

by a warning symbol (as shown to the below).

 

To prevent equipment or media damage, refer to the following

 

safety messages before performing an operation preceded by this

 

symbol.

 

To prevent equipment or media damage, observe all established

 

Electrostatic Discharge (ESD) procedures while handling cables in

 

or near the Circuit Board and Printhead Assemblies.

 

To prevent equipment or media damage, always wear an

 

appropriate personal grounding device (e.g., a high quality wrist

 

strap grounded to avoid potential damage).

 

To prevent equipment or media damage, always remove the

 

Ribbon and Cards from the Printer before making any repairs,

 

unless otherwise specified.

 

To prevent equipment or media damage, take jewelry off of

 

fingers and hands, as well as thoroughly clean hands to remove oil

 

and debris before working on the Printer.

 

 

Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0)

49

 

Page 49
Image 49
FARGO electronic C10, M10 service manual Printer Driver Setup, Safety Messages review carefully