FARGO electronic C10, M10 service manual Replacing the Ribbon Drive Assembly

RESTRICTED USE ONLY Fargo Electronics, Inc.

Replacing the Ribbon Drive Assembly (830147)

Caution: This device is electrostatic sensitive. It may be damaged if exposed to static electrical discharges. (Discharges may be generated by various means, such as walking on a carpeted floor.) Be sure to observe all established Electro-Static Discharge (ESD) procedures while handling cables in or near the Circuit Board and Printhead Assemblies. Always wear an appropriate personal grounding device, such as a wrist strap with integral resistor, connected to an ESD ground to avoid potential damage. At a minimum, make positive contact with the bare metal chassis of the printer with the hand before proceeding with the procedure.

Refer To Drawing 830117-XX. TTR: 10 minutes.

Step Procedure

1Unplug the power cord from the printer.

2Remove the three Screws (130938) from the Ribbon Drive Assembly.

3Disconnect the cable connector from J14 on the Power Circuit Board. See Drawing 830147 for specifications.

4Take the Ribbon Drive Assembly from the printer. (Note: Take care to keep the Shaft from binding with the casing of the Ribbon Drive Assembly before tightening the three Screws.)

Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0) 129