RESTRICTED USE ONLY

Fargo Electronics, Inc.

Replacing the Stepper Motor Assembly (810113)

Caution: This device is electrostatic sensitive. It may be damaged if exposed to static electrical discharges. (Discharges may be generated by various means, such as walking on a carpeted floor.) Be sure to observe all established Electro-Static Discharge (ESD) procedures while handling cables in or near the Circuit Board and Printhead Assemblies. Always wear an appropriate personal grounding device, such as a wrist strap with integral resistor, connected to an ESD ground to avoid potential damage. At a minimum, make positive contact with the bare metal chassis of the printer with the hand before proceeding with the procedure.

Refer To Drawing 830117-XX. TTR: 5 minutes.

Step

Procedure

1Unplug the power cord from the printer.

2Remove two Screws (130938) from the Stepper Motor Assembly that secures the assembly to the printer chassis.

3Disconnect the cable connector from J17 on the Power Circuit Board. See Drawing 810113 for specifications.

4Take the Stepper Motor Assembly from the printer. (Note: Be sure there is adequate grease applied to the pinion gear of the Stepper Motor Assembly. Also ensure that the gear mates properly with the Idler Gear before tightening the two Screws.)

Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0)

132

 

Page 132
Image 132
FARGO electronic M10, C10 service manual Replacing the Stepper Motor Assembly