RESTRICTED USE ONLY | Fargo Electronics, Inc. |
Replacing the Power Circuit Board (140302)
Refer To Drawing 830179.
TTR: 20 minutes.
Step | Procedure |
|
|
1 | Unplug the power cord and any external cables from the printer. |
|
|
2 | Refer to drawing 8301XX to remove the Screw (130971), Screw |
| (130939),Washer (130949), and Cable Clamp (140013) from the Power Circuit |
| Board Power (drawing 830179). |
|
|
3 | Lift up on the Backplate; guide the Power Circuit Board over the lip of the |
| printer baseplate. |
|
|
4 | Place a small piece of tape on each cable; write the cable connection location |
| on that tape. |
|
|
5 | Remove all of the cables from the Circuit Boards. |
|
|
6 | Remove the two Screws (130971) that secure the Print Circuit Board to the two |
| Standoff Screws (140047). |
|
|
7 | Use the thumb and index fingers of both hands to carefully pry the Print Circuit |
| Board from the Power Circuit Board. |
|
|
8 | Take the two Screws (130971) screws from the heatsink and the two corner |
| Screws (130971). |
|
|
9 | Remove the Power Circuit Board from the backplate. (Note: Apply a thin layer |
| of heatsink compound to the back of the heatsink for optimal heat transfer into |
| the backplate when replacing the Power Circuit Board. Attach the cables. Be |
| sure to calibrate the printer so it functions properly.) |
|
|
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0) | 119 |
|