Simplicity 7800071 Attaching A Trailer, Mower Removal And Installation, Operation, 44” DECKS

Operation

ATTACHING A TRAILER

The maximum weight of a towed trailer should be less than 200 lbs (91kg). Secure the trailer with an appropri- ately sized clevis pin (A, Figure 9) and clip (B).

Excessive towed loads can cause loss of traction and loss of control on slopes. Reduce towed weight when operating on slopes. The surface being driven on greatly impacts traction and stability. Wet or slippery surfaces can greatly reduce traction and the ability to stop or turn. Carefully evaluate the surface conditions before operat- ing the unit and trailer, and never operate on slopes greater than 10°. See SLOPE OPERATION and TOWED EQUIPMENT in the safety section of this manual for additional safety information.

A

B

Figure 9. Trailer Weight Recommendations

A.Clevis Pin

B.Clip

MOWER REMOVAL AND

INSTALLATION

NOTE: Perform mower installation and removal on a hard flat surface such as a concrete floor.

Removal

1.Disengage the PTO, lock the ground speed levers into their neutral lock positions, turn off the ignition, remove the key, and wait for all moving parts to stop.

2.Place a 2 x 4 or similiar support under each end of the mower deck, then lower the cutting height adjust- ment lever to its lowest position. See “CUTTING HEIGHT ADJUSTMENT”.

3.Pull back on the tensioning idler (D, Figure 10) in the direction indicated by the arrow, and remove the mower belt from the PTO pulley (C).

(Continued Next Page)

	C
	B
A	D
44” DECKS

Figure 10. Mower Belt Routing

A.Arbor (Blade Spindle) Pulley

B.Stationary Idler

C.PTO Pulley

D.Tensioning Idler

14