Pioneer HTZ656DVD manual SR+ Setup for Pioneer plasma displays, Switching on the SR+ mode

Other connections 09

Important

•With an SR+ cable connected, the remote must now be pointed towards your plasma display rather than the remote sensor of this unit in order to control this system.

•Use a 3-ringed miniplug SR+ cable to connect the CONTROL IN jack of this unit through a media receiver to the CONTROL

OUT jack of your plasma display.1

Before you can use the extra SR+ features, you need to make a few settings in the unit. See SR+ Setup for Pioneer plasma displays below for detailed instructions.

SR+ Setup for Pioneer plasma displays

Make the following settings if you have connected a Pioneer plasma display to this unit using an SR+ cable. Note that the number of video inputs available will depend on the plasma display you’ve connected.

1	Press SHIFT+SR+ on the remote.
2	Use the	to select SETUP, then
press ENTER.
3	Use	to select the setting you want.

•VoL.C OFF – This unit does not control the volume of the plasma display.

•VOL.C ON – When this unit is switched to one of the inputs that use the plasma display (DVD, or another one of functions below), the volume on the plasma display is muted so only sound from this system is heard.

4Assign any input source connected to the plasma display to the corresponding input number.

Use	to select the source (DVD, LN
(LINE) or USB), then		to select the input
number.

This matches this unit’s input source with a

numbered video input on the plasma display.2 For example, select the LN PDP3 setting if the video output of your line component is connected to video input 3 on the plasma display. TVTN switches the plasma display to its built-in tuner and NONE leaves the plasma display input as is (no switching takes place).

5 When you're finished, press ENTER.

Switching on the SR+ mode

1 Press SHIFT+SR+ on the remote.

2 Use to select SR+ ON then press

ENTER.

To switch SR+ control off, select SR+ OFF.

•If you disconnect the SR+ cable or switch the plasma display off while SR+ is on, the SR+ ON setting remains.

•The SR+ setting is maintained even after switching this system into standby then back on. Automatic muting will be effective when this system is switched on.

English Deutsch Français Italiano Nederlands Español

Note

1You won’t be able to use the remote sensor of this unit with the CONTROL IN jack of this unit connected to the CONTROL OUT jack of your plasma display. You can use the remote sensor of the plasma display (even in standby) as long as the power isn’t switched off.

2The PDP5 input may be called ‘PC Input’ (or similar) on your plasma display.

33

En