Surround sound settings
Chapter 6
Surround sound settings
06
English
Using the Setup menu
From the Setup menu you can access all the
surround sound settings of the system1, including channel levels, speaker distances and dynamic range adjustment. The Auto MCACC feature (page 9) should give you the best surround sound setup. However you may find that by further adjustment of the surround sound settings you can improve the surround sound in your listening room.
1 Press SHIFT+SETUP and use then ENTER to choose the setting you want to adjust.
The available settings are shown in the front panel display.2
2 Use to adjust then press ENTER to confirm and exit.
•Note that using the Auto MCACC (page 9) again overwrites the speaker settings.
Channel level setting
Set the relative channel levels from your main listening position.3
Use to switch between channels in the following order:
•L – Front left speaker
•C – Center speaker
•R – Front right speaker
•SR – Surround right speaker
•SL – Surround left speaker
•SW – Subwoofer
The channel level range is ± 10 dB.
Speaker distance setting
Specifies the distance from your listening position to your speakers.
When DISTANCE appears, press ENTER, then
use to adjust the distance, and to switch between the following speakers:
•L – Front left speaker
•C – Center speaker
•R – Front right speaker
•SR – Surround right speaker
•SL – Surround left speaker
•SW – Subwoofer
Each speaker can be adjusted between 0.3 m and 9.0 m. The default setting is 3.0 m.
Dynamic Range Control
Specifies dynamic range adjustment to Dolby Digital or some DTS soundtracks. If low level sound or dialog seem difficult to hear properly, this can help by bringing up the low level sounds, while controlling high level peaks.
•DRC OFF (default) – No dynamic range adjustment (use when listening at higher volumes)
•DRC MID – Mid setting
•DRC HIGH – Dynamic range is reduced (loud sounds are reduced in volume while quieter sounds are increased)
Deutsch Français Italiano Nederlands Español
Note
1There are other settings you can adjust from the Setup menu; these are explained in Improving poor FM reception on page 12 and Dimming the display on page 37.
2The setup menu is exited automatically after 5 minutes of inactivity.
3• You can’t adjust center/surround when Stereo or Virtual playback is selected (or with stereo sources using the Auto mode).
• The Channel level setting is not available when headphones are connected.
• The speaker volume can be adjusted at any time by pressing SHIFT+TEST TONE and then using to adjust the channel levels. The test tone automatically moves from speaker to speaker in the order listed above. You should hear the test tone at the same volume from each speaker when seated in the main listening position. Press ENTER when you’re finished.
• Since the subwoofer produces
25
En
