BM 1609929T61
SANDING DISC ASSEMBLY
BACKING PAD
!WARNING Before attaching a backing pad be sure its maximum
safe operating speed is not exceeded by the nameplate speed of the tool.
!WARNING Wheel guard may not be used for most sanding
operations. Always reinstall wheel guard when converting back to grinding operations.
TO INSTALL BACKING PAD AND
SANDING DISC
Disconnect tool from power source. Attach hand guard (Fig. 1). Set the tool on its top side (spindle up). Place the rubber backing pad onto the spindle shaft. Center the sanding disc on top of the backing pad. Insert the lock nut through the disc and thread onto the spindle as far as you can with your fingers. Press in the spindle lock, then tighten the backing pad securely with lock nut wrench (Fig. 8).
TO REMOVE: Reverse procedure.
FIG. 8 SPINDLE
LOCK
SPINDLE
RUBBER
BACKING
PAD
| SANDING | |
| DISC | |
| ||
WIRE | LOCK NUT | |
BRUSH | ||
|
WIRE BRUSH ASSEMBLY Before attaching a wire brush be sure its maximum
safe operating speed is not exceeded by the nameplate speed of the tool.
Before assembling wire brush to this tool, disconnect from the power source. Attach hand guard (Fig. 1). Wire brushes are equipped with their own threaded hub, simply thread on to spindle. Be sure to seat against shoulder before turning tool “ON”.
TO REMOVE: Reverse procedure.
WIRE WHEEL ASSEMBLY
Before assembling wire wheel to this tool, disconnect from the power source. Attach Type 27 guard (Fig. 2). Wire wheels are equipped with their own threaded hub, simply thread on to spindle. Be sure to seat against shoulder before turning tool “ON”.
TO REMOVE: Reverse procedure.
MOTOR HOUSING RELEASE LEVER | FIG. 9 |
(Model |
|
Your tool is equipped with a motor housing |
|
release lever that will allow you to rotate the |
|
spindle in either direction 90˚. To use this |
|
feature, pull release lever in direction of |
|
arrow to release housing, and rotate housing |
|
until it clicks into place (Fig. 9) |
|
