Disconnect battery pack
from tool before making
any assemb ly, adjust ments or changing
accessories. Such preventive safety
measures reduce the risk of starting the tool
accidentally.
INSERTING AND REMOVING
ACCESSORIES
To avoid loss of control,
ensure bit is locked in chuck
by pulling on bit after it has been inserted.
The c huck acc epts only sta ndard 1/ 4"
hexagonal shank accessories with power
groove.
Your tool is equipped with a quick release
chuck. T o inser t an accessory , simpl y pull
locking sleeve forward, insert desired
accessory into chuck and release locking
sleeve (Fig. 2).
To remove an accessory, pull locking sleeve
forward and simply remove it from the chuck.
LOCKING SLEEVE
FIG. 2
SCREWDRIVER
BIT
BIT HOLDER
SCREWDRIVER BIT
CHUCK
-10-
Assembly
!
WARNING
Operating Instructions
VARIABLE SPEED CONTROLLED
TRIGGER SWITCH
Your tool is equipped with a variable speed
trigger switch. The tool can be turned "ON" or
"OFF" by squeezing or releasing the trigger.
The speed can be adjusted from the minimum
to maximum nameplate RPM by the pressure
you apply to the trigger. Apply more pressure
to increase the speed and release pressure to
decrease speed (Fig. 1).
BRAKE
When the trigger switch is released it activates
the brake to stop the chuck quickly. This is
especially useful in the repetitive driving and
removal of screws.
FORWARD/REVERSING
LEVER & TRIGGER LOCK
After tool use, lock trigger in
“OFF” position to help prevent
accidental starts and accidental discharge.
Your tool is equipped with a forward/
reversing lever and trigger lock located above
the trigger (Fig. 3). This lever was designed for
changing rotation of the bit, and for locking the
trigger in an “OFF” position.
For forward rotation, (with chuck pointed away
from you) move the lever to the far left.
For reverse rotation move the lever to the far
right. To activate trigger lock move lever to the
center off position.
Do not change direction of
rotation until the tool
comes to a complete stop. Shifting during
rotation of the chuck can cause damage to the
tool.
!
WARNING
!
CAUTION
!
WARNING
FIG. 3
FORWARD/REVERSING
LEVER & TRIGGER LOCK
HEX-SHANK
DRILL BIT
BM 2609140646 07-09:BM 2609140646 07-09 7/29/09 2:18 PM Page 10