BM 2609140646
MODE SELECTOR SWITCH
The selector switch allows the tool to be set for various Drilling/Impact Driving applications.
The mode selector switch has three settings.
Speed 1 drill only: provides slower speeds for drilling with large diameter bits in wood, metal,
ceramics and plastic.
Speed 2 drill only: provides faster speeds for drilling with small diameter bits in wood, metal,
ceramics and plastic.
Driving with impact action:
Provides high torque and high speed to drive screws, bolts, nuts
and other common fasteners.
Do not operate the selection ! CAUTION switch until the tool comes
to a complete stop. Shifting during rotation of the chuck can cause damage to the tool.
To change speeds slide switch to desired setting (Fig. 4).
To prevent damage to tool always check to make sure the mode selector switch is fully engaged
into desired setting. If you have difficulty fully engaging the switch, lightly squeeze and release the trigger before pushing the switch into desired setting.
FIG. 4
BUILT IN WORK LIGHT
Your tool is also equipped with a light that turns on automatically when the switch is activated, for better visibility when driving (Fig. 1).
BIT STORAGE AREA
Your tool is equipped with a bit and storage area that is conveniently located in the handle base where it is always handy and unlikely to get lost or misplaced (Fig. 5).
BELT CLIP
When the tool is attached to ! WARNING the belt, position yourself to
avoid entanglement with surrounding objects. Unexpected entanglement could cause the tool to fall resulting in injury to the operator or bystanders.
The optional belt clip accessory will allow you to conveniently attach your tool to your belt. This feature will allow you to have both hands free when climbing a ladder or moving to another work area.
The belt clip can be attached to either side of the tool by securing it with a mounting screw. Always make sure you securely tighten the mounting screw before use (Fig. 5).
To use clip, turn tool upside down and attach to your belt.
FIG. 5
