Falcon 36 Operation Manual | Installation |
6HFWLRQ,QVWDOODWLRQ
Before a Falcon 36 Laminator can be installed there are a few requirements that must be met. Make certain that each of the requirements listed in the following preinstallation checklist are met before beginning installation.
CAUTION
Failure to follow the preinstallation checklist
can result in damage to the laminator.
3UHLQVWDOODWLRQ&KHFNOLVW
❒Are doorways and hallways wide enough for the laminator to be moved to the installation site?
❒Is there ample room for the laminator?
A work area must be established that allows for operation in both the front and the rear of the machine and provides space for efficient material flow. Figure
❒Is the environment appropriate for the laminator?
The laminator requires a clean, dust and vapor free environment to operate properly. It must not be located where there is air blowing directly on the machine.
WARNING
The operating environment must be free of dust, flammable liquids and vapors. You can be injured by inhaling chemical vapors. Vapor build up or stored flammable liquids can cause a fire. Excessive dust can damage the laminator.
CAUTION
Do not locate the laminator where air is
blowing directly on the machine. The air flow can cool the rolls unevenly and result in poor quality output.
❒Is there an appropriate power outlet available or has a certified electrician been contacted to wire the laminator directly?
The laminator requires 30A single phase service and a power receptacle that accepts a 30A 250V NEMA
WARNING
Do not attempt to defeat the grounding
feature of the ground plug on the laminator. You can be severely shocked, electrocuted or cause a fire. The three prong plug fits only into a
WARNING
Do not use an extension cord on this
laminator. You can be severely shocked, electrocuted or cause a fire. If you need a longer cable contact a qualified electrician.
WARNING
Do not operate the laminator if the power cord is damaged or frayed. You can be severely shocked, electrocuted or cause a fire. Contact a qualified electrician to replace the cord.
© GBC |