
BM 2609932842
Assembly
BACKING PAD INSTALLATION
The random orbit sander is equipped with a backing pad of soft hardness, which is suitable for general service. Hard and
Extra soft pad - Polishing or sanding large or curved surfaces.
Soft pad - All purpose general sanding and polishing.
Hard pad - Heavy sanding on flat surfaces, especially with coarser abrasives.
To change backing pad, hold pad firmly and remove the screw using a 5 mm hex wrench that secures the backing pad and remove old pad. Align new pad over drive gear on drive spindle. Attention: always be sure the teeth on the drive gear engage into the openings on the backing pad. Replace screw and securely tighten. Damaged or worn backing pads must be replaced immediately (Fig. 2).
FIG. 2
BACKING
SCREW 
PAD
DRIVE
GEAR
INSTALLING ACCESSORIES
The random orbit sander uses
ABRASIVE | FIG. 3 | |
DISC | ||
| ||
A |
|
BACKING
PAD
After considerable service the pad surface will become worn, and the pad must be replaced when it no longer offers a firm grip. If you are experiencing premature wearout of the pad facing, decrease the amount of pressure you are applying during operation of the tool.
FRONT HANDLE
Your sander is equipped with a removable front handle when sanding in tight quarters. To remove handle, remove screw with allen wrench. Always reinstall handle for normal operation. Depending on the task, you may
grip the rear handle alone, the rear handle and the front handle, or the rear handle and the top of the ergonomically contoured soft grip motor housing, which is designed for that purpose (Fig. 1).