BM 2609932842
BACKING PAD DAMPER
Your tool is equipped with an integrated backing pad damper ring. This damper reduces the
NOTE: If you notice steadily increasing
To replace damper ring, remove backing pad as described in “Backing Pad Installation” and remove worn damper ring by pulling firmly out of locating groove. Align notch on damper ring with locating tab on shroud and depress ring with thumbs until shroud seats into groove completely around ring (Fig. 4).
IMPORTANT: Ring should not have bends or ripples when correctly seated.
FIG. 4 | BACKING |
| |
| PAD |
| NOTCH |
LOCATING
TAB
DAMPER
RING
SHROUD
Dust Collection
MICROFILTER DUST CANISTER
The integral dust extraction system collects sanding dust in canister supplied with your sander. For maximum efficiency, the dust canister should be emptied frequently during operation.
!WARNING Your tool is equipped with a dust canister, empty it
frequently, after completion of sanding and before storing the sander. Be extremely careful of dust disposal, materials in fine particle form may be explosive. Do not throw sanding dust on an open fire. Combustion from mixture of varnishes, lacquers, polyurethane, oil or water with dust particles can occur if there is a static discharge, spark introduced in the box, or excessive heat.
REMOVING AND INSTALLING
DUST CANISTER
To attach dust canister, slide canister support in direction of arrow (A) until it stops. Insert mounting clip into the pocket provided on canister. Then slide canister support through mounting clip in direction of arrow (B) and push onto the dust port (Fig. 5).
To remove dust canister, squeeze release tabs on both sides of canister and simply pull away from the tool (Fig. 6).
FIG. 5
A
CANISTER
SUPPORT
DUST
CANISTER 
B 
MOUNTING
CLIP
FIG. 6
RELEASE
TABS
1
2
