BM 1619X08893
Assembly
ATTACHING THE BLADE Disconnect the plug from the power source before
making any assembly, adjustments or changing accessories. Such preventive safety measures reduce the risk of starting the tool accidentally.
1. Press the lock button and turn wrench until lock button engages. Saw shaft is now locked. Continue to depress button, turn wrench clockwise and remove BLADE STUD and OUTER WASHER (Fig. 2).
2. Make sure the saw teeth and arrow on the blade point in the same direction as the arrow on the lower guard.
3. Retract the lower guard all the way up into the upper guard. While retracting the lower guard, check operation and condition of the
LOWER GUARD SPRING.
4. Slide blade through slot in the foot and mount it against the INNER WASHER on the shaft. Be sure the large diameter of the INNER and OUTER washers lay flush against the blade.
5.Reinstall OUTER WASHER. First tighten BLADE STUD finger tight, then TIGHTEN BLADE STUD 1/8 TURN (45˚) WITH THE WRENCH PROVIDED.
Do not use wrenches with longer handles, since it may lead to over tightening of the blade stud.
This clutching action is provided by the friction of the OUTER WASHER against the BLADE and permits the blade shaft to turn when the blade encounters excessive resistance. When the BLADE STUD is properly tightened (as described in No. 5 of Attaching The Blade), the blade will slip when it encounters excessive resistance, thus reducing saw’s tendency to
KICKBACK.
One setting may not be sufficient for cutting all materials. If excessive blade slippage occurs, tighten the blade stud a fraction of a turn more (less than 1/8 turn). OVERTIGHTENING THE BLADE STUD NULLIFIES THE EFFECTIVE- NESS OF THE CLUTCH.
FIG. 2 |
| LOWER GUARD |
|
|
| SPRING |
|
| AUXILIARY HANDLE |
|
|
| UPPER GUARD | /4 |
|
|
| 1 |
|
|
| 1/2 | X |
|
| 1 | |
|
| 3/4 | MBER |
D | LOWER GUARD |
OO | |
| |
| LIFT LEVER |
| SAW SHAFT |
INNER WASHER
Large Diameter Faces Blade
LOCK
BUTTON
LOWER
GUARD
BLADE
BLADE
STUD
Tighten
OUTER WASHER Large Diameter
Faces Blade
Loosen
