Maintenance
Service
!WARNING NO USER SERVICEABLE PARTS INSIDE. Preventive maintenance performed by
unauthorized personnel may result in misplacing of internal wires and components which could cause serious hazard. We recommend that all tool service be performed by a Bosch Factory Service Center or Authorized Bosch Service Station. SERVICEMEN: Disconnect radio unit from power source before servicing.
Service must be performed only by qualified repair personnel. Service or maintenance performed by unqualified personnel may result in a risk of injury.
When servicing, use only identical replacement parts. Follow instructions in the Maintenance section of this manual. Use of unauthorized parts or failure to follow Maintenance Instructions may create a risk of shock or injury.
BATTERIES
Be alert for battery packs that are nearing their end of life. If you notice decreased tool performance or significantly shorter running time between charges then it is time to replace the battery pack. Failure to do so can cause the tool to operate improperly or damage the charger.
Cleaning
To avoid accidents, always disconnect the ! WARNING radio unit from the power supply before
cleaning.
THE MAIN UNIT
Never insert a dirty/scraped disc into unit or allow dirt or sand to enter the unit.
Do not remove the unit suddenly from a very cold area into a warm area. Otherwise moisture condensation may form on the optical lens, preventing proper operation.
Do not leave the unit exposed to direct light sunlight for long periods of time, it may deform or discolor the cabinet and may also cause malfunctioning.
Wipe the unit with a soft cloth. Remove stubborn dirt using a damp cloth that was dipped in soapy water, then wipe dry.
If you intend to use a chemical cleaning cloth, read it’s instruction first.
Do not use alcohol or paint thinners.
Certain cleaning agents and solvents ! CAUTION damage plastic parts. Some of these are:
gasoline, carbon tetrachloride, chlorinated cleaning solvents, ammonia and household detergents that contain ammonia.
Accessories
!WARNING If an extension cord is necessary, a cord with adequate size conductors that is
capable of carrying the current necessary for your tool must be used. This will prevent excessive voltage drop, loss of power or overheating. Grounded tools must use 3- wire extension cords that have
NOTE: The smaller the gauge number, the heavier the cord.
RECOMMENDED SIZES OF EXTENSION CORDS 120 VOLT ALTERNATING CURRENT TOOLS
Tool’s | Cord Size in A.W.G. | Wire Sizes in mm2 | ||||||||
Ampere | Cord Length in Feet | Cord Length in Meters | ||||||||
Rating | ||||||||||
25 | 50 | 100 150 | 15 | 30 | 60 | 120 | ||||
|
| |||||||||
|
|
|
|
|
|
|
|
|
| |
| 18 | 16 | 16 | 14 | 0.75 | 0.75 | 1.5 | 2.5 | ||
| 18 | 16 | 14 | 12 | 0.75 | 1.0 | 2.5 | 4.0 | ||
| 18 | 16 | 14 | 12 | 0.75 | 1.0 | 2.5 | 4.0 | ||
| 16 | 16 | 14 | 12 | 1.0 | 2.5 | 4.0 | — | ||
| 14 | 12 | — | — | — | — | — | — | ||
|
|
|
|
|
|
|
|
|
| |
13
