Bose 40 manual Connecting your system, Setting Up, Figure, Ridge

Setting Up

Connecting your system

Once you have selected locations for your speakers, CD changer, and interface, connect the system.

CAUTION: Make sure all components are unplugged from the power outlet befor e you begin hooking up the system.

Figure 6

Speaker cable connection to the Jewel Cube speaker

Connecting the Jewel Cube® speakers to the Acoustimass® module

1.Insert the connector of each speaker cable fully into the jack on the rear of each speaker (Figure 6). Match the ridge of the connector to the notch at the top of the jack.

2.Connect each 20-foot (6.1 m) cable to the corresponding left or right green jack on the Acoustimass module. Speaker cables have green connectors at one end, with L (left) and R (right) molded into the connectors.

To lengthen the cable, connect speaker wire with male phono (RCA) plugs on each end to your supplied speaker cable. Use a female-to-female adapter (“barrel” connector). Or, splice in 18-gauge (.75 mm2) or thicker cord (connecting + to + and – to –). To purchase extension wire, see your dealer, electronics store, or call Bose® Customer Service.

Ridge Notch

8 December 20, 2001 AM189858_03_V.pdf