Operating a
Using the HOUSE button
The HOUSE button lets you control all connected rooms as if they were one. When you press the HOUSE button, an empty box indicator is displayed for each connected room. Any button pressed after that (any source button, VOLUME, MUTE, or SLEEP) affects every room. When you are done listening you can press OFF to turn off the entire system.
Note: If you do not press any additional buttons after pressing HOUSE, pressing HOUSE again cancels HOUSE mode.
Press the HOUSE button before each command to apply that command to all rooms:
Press … | To do this … |
HOUSE then a source | Play the selected source in all connected rooms. |
HOUSE then VOLUME ▲/▼ Adjust the volume up or down by the same amount in all | |
| rooms that are on, or all connected rooms if they are all off. |
| The system remembers the differences among the original |
| room volume settings. |
HOUSE then MUTE | Silence all connected rooms that are on, even if any were |
| previously muted individually. To cancel this command, press |
| HOUSE then MUTE again. Any rooms that were muted before |
| this command was given stay silent until individually unmuted. |
| If you unmute an individual room after it was muted by a |
| HOUSE - MUTE command, the other rooms remain silent until |
| each one is unmuted individually. Pressing HOUSE then |
| VOLUME ▲unmutes all muted rooms. |
HOUSE then SLEEP | Set the SLEEP timer for all rooms that are on. The SLEEP time |
| selected applies to all rooms that are on even if they are |
| playing different sources. If the SLEEP timer was already set |
| in one or more rooms, the display shows the longest time |
| already set. You can accept this time or change it for all the |
| rooms. To cancel the HOUSE - SLEEP command, press |
| HOUSE, SLEEP, CLEAR, and then DONE. |
HOUSE then OFF | Turn off the entire system. |
Note: Instead of setting one sleep time for the entire house, you can set different sleep times for individual rooms by using the ROOM button to select each room and setting SLEEP.
When two or mor e rooms are controlled as one, adjusting the SLEEP time affects all rooms (indicated by boxed letters).
Using more than one Personal™ music center
If you have a
To add a new music center to your system, follow the setup instructions on page 13. Be sure to install the batteries and turn it on for the first time close to the
AM189858_03_V.pdf | December 20, 2001 | 35 |