Setting Up
Completing connections and turning on the Acoustimass® module
Figure 13
Turning on the Acoustimass module
AUDIO
INPUT
RIGHT
1. | Plug the Acoustimass® module power cord into an AC power (mains) outlet. |
2. | Plug the |
3. | When you have checked all connections, be sure to turn the Acoustimass module power |
| switch on (Figure 13). It is not necessary to turn the module off after each use. The system |
| turns on and off automatically as it receives a signal from the Personal™ music center. |
OUTPUTS
TO
CUBE
SPEAKERS
OFF
POWER
ON
LEFT
Turn the system off using the Personal music center. |
Note: Your speakers will not operate unless you complete all cable and power connections before turning on the system.
CAUTION: Be sure the three shipping screws on the bottom of the CD changer have been removed before turning on the system.
Setting up the Personal music center
Set up the Personal music center after the rest of the system is connected, plugged in, and the Acoustimass module has been turned on.
Note: When batteries are first installed in the Personal music center, it sets up a radio- frequency link with the closest
1.Hold the Personal music center within a few feet of the
2.Slide open the battery compartment on the back of the Personal music center (Figure 14).
3.Insert 4 AAA or
4.Slide the battery compartment cover back into place.
5.Turn the Personal music center over and touch the screen to wake it up if it appears blank. Press ON/OFF, FM, or any other source button to turn the system on.
If the Personal music center continuously displays “NO RESPONSE,” you need to try to establish its link with the
Figure 14 | Battery compartment cover |
| |
Installing batteries and waking | 4 AAA |
up the display for the first time | batteries |
a. Install batteries | b. Turn over and wake up display |
Note: Replace the batteries when the LOW BATTERY message first appears. See “Replac- ing batteries” on page 36. Alkaline batteries are recommended.
AM189858_03_V.pdf | December 20, 2001 | 13 |