Bose SOUNDLINK AIR S AFETY I

English – 3

SAFETY INFORMATION

Please dispose of used batteries properly, following local regulations. Do not incinerate.

1. Read these instructions.

2. Keep these instructions.

3. Heed all warnings.

4. Follow all instructions.

5. Do not use this apparatus near water.

6. Clean only with a dry cloth.

7. Do not block any ventilation openings. Installin accordance with the manufacturer’s instructions.

8. Do not install near any heat sources, such asradiators, heat registers, stoves, or other apparatus(including

amplifiers) that produce heat.

9. Protect the power cord from being walked on orpinched, particularly at plugs, convenience receptacles, and

the point where they exit from the apparatus.

10. Use only attachments/accessories specified by the manufacturer.

11. Unplug this apparatus during lightning storms or when unused for long periods of time.

12. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any

way, such as power supplycord or plug is damaged, liquid has beenspilled or objects have fallen into the apparatus,

the apparatus has been exposed torain or moisture, does not operate normally, or has been dropped.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of

the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates,uses, and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications. However, this is no guarantee

that interference will not occur in a particular installation. Ifthis equipment does cause harmful interference to radio or

television reception, which can be determined by turningthe equipment off and on, you are encouraged to try to correct the

interference byone or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment to an outlet on a different circuit than the one to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technicianfor help.

Note:

•Where the mains plug or appliance coupler is used as the disconnect device, suchdisconnect device shall

remain readily operable.

•The product must be used indoors. It is neitherdesigned nor tested for use outdoors, in recreation vehicles,

or on boats.

•This product is intended to be used only with the power supply provided.

•The product label is located on the bottom of the product.

Bose Corporation hereby declares that this product is in compliance with the essential requirements and other

relevant provisions of Directive 1999/5/EC and all other applicable EU directive requirements. The complete

Declaration of Conformity can be found at www.Bose.com/compliance.

Whippet_OG.book Page 3 Monday, August 6, 2012 11:11 AM