Using the Alarms, To pause the alarm for 10 minutes

Operating Your Wave® Radio

Using the Alarms

Wave Radio

Wave Radio

Control panel

Remote control

To stop the alarm – Press On/Off. The indicators remain lit.

Or, if	you	do not press On/Off, the tone	alarm shuts off in 30 minutes, the	On/Off	On
					Off

radio		alarm shuts off in 60 minutes.

The alarm automatically resets to repeat daily.

To pause the alarm for 10 minutes			– Press Sleep/Snooze or Sleep to
have the radio	or tone	alarm repeat in 10 minutes. When the alarm is		Sleep/Snooze
				Sleep
in both radio and tone mode, press Sleep/Snooze or Sleep to pause the tone				Sleep

for 10 minutes and turn on the radio. Press Sleep/Snooze or Sleep again to
silence the radio – the tone repeats in 10 minutes.
You can repeat the pause cycle as many times as you want. If you do not
press any button while the tone is sounding, it shuts off in 30 minutes.

To set the volume of the radio alarm			– The radio alarm turns on and
gradually increases to the last volume setting used. You can select a volume				Volume
setting with the radio on or off.				Volume

gradually increases to the last tone setting used. You can set a louder or softer tone by pressing Volume up or down while the tone is sounding.

Volume


To use the alarm during a power loss	– Press On/Off to silence the		Use the control panel to
alarm. The backup battery runs the alarm for approximately 48 hours without			operate the alarm dur-
			operate the alarm dur-
AC power. To conserve power, only the tone alarm sounds even if the radio		On/Off	ing a power loss.
alarm is selected. Normal operation resumes when power is restored.

Replace the 9V battery after an extended power loss.

Note: The Wave radio does not respond to remote control during a power loss.

AM255380_01_V.PDF