Setting Up Your Wave® Radio
Installing the battery
WARNING: Keep the remote control battery away from children. It may cause a fire or chem- ical burn if mishandled. Do not recharge, disassemble, heat above 100˚C (212˚F), or inciner- ate. Dispose of used battery promptly. Replace only with a battery of the correct type and model number.
The 9V battery maintains clock and alarm settings and operates the Wave radio’s alarm sys- tem for approximately 48 hours during a power loss, or while the radio is temporarily unplugged. Operating without this battery results in the loss of clock and alarm settings, and station presets in the event of a power loss, but does not harm the radio.
Use a standard 9V battery (IEC 6F22 in Europe), available at most retail stores.
Note: The battery does not provide power for Wave radio operation or for the display.
1.Carefully turn your radio upside down.
2.Locate the battery compartment on the bottom (Figure 2).
3.Press the arrow on the cover to slide the compartment open.
4.Lift the battery clip out of the compartment and align it with the battery as shown.
5.Snap the terminals together firmly.
6.Place the battery in the compartment and slide the cover closed. Then turn the radio right side up.
Figure 2
Installing the battery
AM255380_01_V.PDF | October 22, 2001 | 9 |
