Bose X manual Removing an attached boom microphone cable, Attaching the boom microphone cable

GETTING YOUR HEADSET READY FOR USE

note the important markings for left (L) and right (R) above each ear- cup. These markings indicate which ear each earcup is intended to fit over.

Removing an attached boom microphone cable

1.Use a flat-tipped screwdriver to loosen the two screws at the base of the boom microphone cable assembly.

2.Pull the cable assembly straight out from the earcup to which it is attached (Figure 6).

CAUTION: Do not twist the boom microphone cable while discon- necting it. Twisting can damage the connector pins.

Figure 6

Pulling the cable assembly straight out from the earcup

L for left

Connector Access pins cover

Cable Connector

assembly pins

Attaching the boom microphone cable

Before you attach the boom microphone, make sure that the cable connector and its earcup connector are clean and free of debris.

1.Use a flat-tipped screwdriver to loosen the two screws on the access cover near the bottom of the earcup where you want to attach the boom microphone.

2.Remove the cover to reveal the connector pins on the earcup.

3.Carefully line up the connector to the small connector pins on the panel (Figure 7 on page 12).

CAUTION: An improperly aligned connector will not make the con- nections neccessary for proper operation, and may cause damage.

11