Bose X manual Mounting the connector

GETTING YOUR HEADSET READY FOR USE

CAUTION: Do not attempt to pull the connector out without first pull- ing back on the sleeve. Forcing the connector out will cause damage to the cable and/or your aircraft instrument panel.

Figure 11		Slide sleeve
	Align keyway
Attaching and removing the		to release
cable

Mounting the connector

Mount the connector into a cutout, as shown in Figure 12 below.

Connect the eight wires as follows:

•Two for the microphone

•Two for audio

•One for power

•One for ground

•Two for audio shields

Audio and microphone wires should be connected to the back of the existing microphone and headphone jacks, leaving existing jacks intact for use with conventional headsets. This is usually the fastest installation method. Also refer to Figures 13-15 on page 18.

Figure 12

Harness connector and schematic

"

	•
	•
T	•
	•
T	•
	•

15