28
Chapter 4 The Effects Explained
Drive
Adjusts the depth of distortion.
Bass
Adjusts the tone for the low frequency range.
Treble
Adjusts the tone for the high frequency range.
Level
Adjusts the volume.
DELAY
This effect adds delayed sound to the direct sound, giving
more body to the sound or creating special effects.
Parameter Value
On/Off Off, On
Type Single, Pan
Delay Time 0 ms–1800 ms,
BPM –BPM
Delay Time (Fine) 0 msec–20 msec
Tap Time 0 %–100 % (Type=Pan)
Feedback 0–100
High Cut Filter 700 Hz–11.0 kHz, Flat
Effect Level 0–120
On/Off
Turns the delay effect on/off.
Type
This selects which type of delay.
Single:
By adjusting the delay time and feedback, you can obtain a
normal delay effect.
Pan:
This delay is specifically for stereo output. This allows you to
obtain the tap delay effect that divides the delay time, then
deliver them to L and R channels.
fig.04-01
Delay Time
This determines the delay time.
* When set to BPM, the value of each parameter will be set
according to the value of the Master BPM (p. 46) specified for
each patch. This makes it easier to achieve effect sound settings
that match the tempo of the song (synchronizing the time to
twice or four times the time length of the BPM when the set
time is increased).
When setting to BPM, press PARAMETER [ ] to display
the Master BPM settings screen.
Delay Time Fine
Make fine adjustments to the delay time.
Tap Time
Adjusts the delay time of the right channel delay. This setting
adjusts the right channel delay time relative to the left
channel delay time (considered as 100 %).
Feedback
“Feedback” is returning a delay signal to the input. This
parameter determines the amount of feedback. A higher
value will increase the number of the delay repeats.
High Cut Filter
The high cut filter cuts the frequency contents that are higher
than the set frequency. This parameter adjusts the frequency
where the high cut filter starts working. When it is set to
“Flat,” the high cut filter is off or has no effect.
Effect Level
This adjusts the volume of the delay sound.
After [TAP] is pressed several times, the interval
between presses of the button is then used as the delay
time setting.
You can change the Master BPM by setting the delay
time to the BPM and pressing [TAP] several times.
INPUT OUTPUT L
OUTPUT R
Feedback
Delay Time Effect Level
Effect Level
DELAY
Tap Time