• Wear safety goggles or other eye protection. Hammering and drilling operations cause chips to fly. Flying particles can cause permanent eye damage.
• Bits, sockets and tools get hot during operation. Wear gloves when touching them.
• Do not operate this tool for long periods of time. Vibration caused by tool action may be harmful to your hands and arms. Use gloves to provide extra cushion and limit exposure by taking frequent rest periods.
• Wear appropriate personal hearing protection during use. Under some conditions and duration of use, noise from this product may contribute to hearing loss.
WARNING: Impact wrenches are not torque wrenches. Do not use this tool for tightening fasteners to specified torques. An independent, calibrated torque measurement device such as a torque wrench should be used when under tightened or over tightened fasteners can lead to the failure of the joint.
WARNING: ALWAYS use safety glasses. Everyday eyeglasses are NOT safety glasses. Also use face or dust mask if drilling operation is dusty. ALWAYS WEAR CERTIFIED SAFETY EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CPA Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NOSH/OSHA respiratory protection.
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the state of California to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:
• lead from
• crystalline silica from bricks and cement and other masonry products, and
• arsenic and chromium from
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles.
• Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling, and other construction activities. Wear protective clothing and wash exposed areas with soap and water. Allowing dust to get into your mouth, eyes, or lay on the skin may promote absorption of harmful chemicals.
WARNING: Use of this tool can generate and/or disperse dust, which may cause serious and permanent respiratory or other injury. Always use NOSH/OSHA approved respiratory protection appropriate for the dust exposure. Direct particles away from face and body.
Symbols
•The label on your tool may include the following symbols. The symbols and their definitions are as follows:
V..................voltsA...................amperes
Hz | hertz | W | watts | ||||||
min | minutes |
|
| or AC | alternating current | ||||
|
|
|
| or DC.... | direct current | no | no load speed | ||
|
|
|
| ||||||
|
|
|
|
| Class I Construction |
|
|
| earthing terminal |
|
|
| ................. |
|
| .................. | |||
|
|
|
|
|
|
|
| ||
|
|
|
|
| (grounded) |
|
| ................. | safety alert symbol |
|
|
| ................. | Class II Construction | .../min or rpm... | revolutions or | |||
|
|
|
|
| (double insulated) |
|
|
| reciprocation per minute |
|
|
|
| ............. | Read instruction manual before use |
|
| .................. | Use proper respiratory protection |
|
|
| ................. | Use proper eye protection |
|
| .................. | Use proper hearing protection | |
IPM | impacts per minute | BPM | beats per minute | ||||||
4
