LED Worklight (Fig. F)

There is a worklight (5) located just above the trigger switch (1). The worklight will be activated when the trigger switch is squeezed.

NOTE: The worklight is for lighting the immediate work surface and is not intended to be used as a flashlight.

Quick Release Chuck (FIG. G)

NOTE: The chuck accepts 1/4 inch (6.35 mm) hex accessories only.

WARNING: Place the switch in the locked off (center) position and remove battery pack before changing accessories.

CAUTION: Use only impact accessories. Non-impact accessories may break and cause a hazardous condition. Inspect accessories prior to use to ensure that they contain no cracks.

To install an accessory, firmly insert the accessory completely into the quick release chuck

(4) until an audible click is heard and verify the accessory is locked in place by tugging on it.

To remove an accessory, pull the chuck collar

(3) away from the front of the tool, remove the accessory and release the collar.

On Board Bit Storage

A bit storage holder (6) is built-in to the area on the side of the battery.

F

5

G

3

Troubleshooting

Problem

Possible Cause

Possible Solution

• Unit will not start.

• Battery pack not installed

• Check battery pack

 

properly.

installation.

 

• Battery pack not charged.

• Check battery pack charging

• Battery pack will not

• Battery pack not inserted into

requirements.

• Insert battery pack into

charge.

charger.

charger until green LED appears.

 

• Charger not plugged in.

• Plug charger into a working

 

 

outlet. Refer to “Important Charging

 

• Surrounding air temperature

Notes” for more details.

 

• Move charger and battery

 

too hot or too cold.

pack to a surrounding air temperature of

 

 

above 40 degrees F (4.5°C) or below

• Unit shuts off abruptly.

• Battery pack has reached its

105 degrees F (+40.5°C).

• Allow battery pack to cool

 

maximum thermal limit.

down.

 

• Out of charge. ( To

• Place on charger and

 

maximize the life of the

allow to charge.

 

battery pack it is designed

 

 

to shutoff abruptly when

 

 

the charge is depleted.)

 

For assistance with your product, visit our website at www.bostitch.com for a list of service centers, or call the Bostitch Customer Care Center at (888) 848-5175.

9

Page 9
Image 9
Bostitch BTC440LB instruction manual Troubleshooting