Troubleshooting HP Fast InfraRed

Receiver Problems

Troubleshooting HP Fast InfraRed Receiver Problems

Item

Explanation

 

 

FIR port status

Make sure that the printer is in READY mode and that the FIR port

indicator does not

you are printing from is IRDA-compliant and within the range of

light up.

operation described in the user guide for the HP Fast InfraRed

 

Receiver.

 

Make sure that the HP Fast InfraRed Receiver is properly connected

 

to the printer.

 

Print a configuration page (see page 134). Make sure that “FIR POD

 

(IRDA Compliant)” is printed under Installed Personalities and

 

Options.

 

 

Connection cannot be

Use a device that is IRDA-compliant; look for an IRDA symbol on

established or seems to

the device or see the computer’s user guide for IRDA specifications.

take longer than usual.

Make sure that the operating system on your computer includes an

 

 

FIR driver and your application uses an HP LaserJet 4050, 4050 N,

 

4050 T, 4050 TN, or compatible driver. (Note that complex pages

 

take longer to print.)

 

Position the HP Fast InfraRed Receiver within the range of operation

 

described in the user guide for the HP Fast InfraRed Receiver. Make

 

sure that no object is blocking the connection. (This object could be

 

a hand, paper, books, or even bright light.)

 

Make sure that the two IR ports are clean (free from dirt and grease).

 

Bright light of any kind (sunlight, incandescent light, fluorescent

 

light, or light from an infrared remote control, such as those used

 

for TVs and VCRs) shining directly into one of the IR ports might

 

cause interference. Make sure that no bright light is shining directly

 

into either IR port.

 

Position the portable device closer to the FIR port on the printer.

 

 

The printer prints only

The connection has been broken during transmission. If you move

part of a page or

the portable device during transmission, the connection can be

document.

broken. IRDA-compliant devices are designed to recover from

 

temporary connection interruptions. You have up to 40 seconds to

 

re-establish the connection (depending on the portable device

 

being used).

The print job has been properly sent, but the printer will not print.

If the connection is broken before the entire print job has been transmitted to the printer (printing has not yet started), the printer may not print any of the job. Press [Cancel Job] to clear the printer’s memory. Then, reposition the portable device within the range of operation described in the user guide for the HP Fast InfraRed Receiver, and print the job again.

EN

Chapter 4: Problem Solving 129

Page 151
Image 151
HP 4050 manual Troubleshooting HP Fast InfraRed Receiver Problems