HP 4050 Initializing, Not Functional, Spinning UP, ENV Feeder Load, Type Size, External Device

Printer Messages (Continued)

Message	Explanation or Recommended Action
EIO n DISK	The disk accessory card takes a long time to initialize. The first
INITIALIZING	parameter is the accessory slot number for this disk accessory card.
EIO n DISK	The EIO disk is not working correctly.
NOT FUNCTIONAL	Remove the EIO disk from the slot indicated.
	Replace it with a new EIO disk.
EIO n	Wait for the message to disappear (approximately 5 minutes). If the
INITIALIZING	printer EIO card is operating correctly and communicating with the
alternates with	network, this message disappears after approximately one minute
	and no action is required.
DO NOT POWER OFF	If the EIO card is unable to communicate with the network, this
	message remains for five minutes and then disappears. In this case
	the printer is not communicating with the network (even though the
	message is no longer present). The problem may be a bad EIO card,
	a bad cable or connection on the network, or a network problem.
	Contact your network administrator.
EIO n DISK	The disk accessory is initializing. The first parameter is the accessory
SPINNING UP	slot number for this accessory card.
ENV FEEDER LOAD	Load the requested envelope type and size into the envelope feeder.
[TYPE] [SIZE]	Make sure the envelope size and type are set correctly from the Paper
	Handling Menu in the printer’s control panel (page B-5).
	Press [Go] if the desired envelope is already loaded in the feeder.
	Press [- Value +] to scroll through the available types and sizes. Press
	[Select] to accept the alternate type or size.
EXTERNAL DEVICE	When an external paper handling device is connected to the printer,
INITIALIZING	it must initialize after the computer boots or after coming out of
	PowerSave mode.
FLASH DEVICE	The flash DIMM had a critical failure and no longer can be used.
FAILURE	Remove the flash DIMM and replace it with a new one.
FLASH FILE	The requested operation could not be performed. You might have
OPERATION FAILED	attempted an illegal operation, such as trying to download a file to a
	non-existent directory.
FLASH FILE	Delete files from the flash DIMM. Use HP Resource Manager to
SYSTEM IS FULL	download or delete files and fonts. (See the software help for more
	information.)
FLASH IS	The flash DIMM is protected and no new files can be written to it.
WRITE PROTECTED	Disable the write protection through HP Resource Manager.

EN

Chapter 4: Problem Solving 105