HP 4050 manual Control Panel Menus B-17

Configuration Menu (Continued)

Item	Values	Explanation
RAM DISK=OFF	OFF	Determine how the RAM disk is configured.
	ON	This item appears only if there is no optional
	AUTO	hard disk installed and the printer has at least
		16MB of memory.
		OFF: The RAM disk is disabled.
		ON: The RAM disk is enabled. Configure the
		amount of memory to be used through the
		following item: RAM DISK SIZE.
		Note
		If the setting is changed from OFF to ON or from
		OFF to AUTO, the printer will automatically
		reinitialize when it becomes idle.
RAM DISK SIZE=xxxK	0K and up	Determine the size of the RAM disk. This item
	(This value	appears if RAM DISK=ON or AUTO.
		Press [-Value+]to change settings by
	depends on the
	amount of	increments of 100.
	installed	Note
	memory.)	This setting cannot be changed if RAM DISK=
		AUTO. Changing this value will cause the printer
		to reinitialize when it becomes idle.

JAM RECOVERY=	AUTO
AUTO	ON
	OFF

Determine how the printer behaves when a paper jam occurs.

AUTO: The printer automatically selects the best mode for printer jam recovery (usually ON). This is the default setting.

ON: The printer automatically reprints pages after a paper jam is cleared.

OFF: The printer does not reprint pages following a paper jam. Printing performance might be increased with this setting.

MAINTENANCE	OFF	This item appears only after the PERFORM
MESSAGE=OFF		PRINTER MAINTENANCE message displays.
		OFF: The PERFORM PRINTER MAINTENANCE
		message will be cleared and will not be
		displayed again until the next maintenance is
		due.
		The message should not be turned off unless
		the printer maintenance has been performed.
		If the required maintenance is not performed,
		the printer’s performance will degrade.
		For more information, see page 87. To order
		the Printer Maintenance Kit, see page 11.

EN

Control Panel Menus B-17