Parts List
FRB5R, FRB6R or FRB8R
Drop Ceiling Support Rails | ULM Connectors |
| not to scale |
Support Rail Mounting Hardware |
not to scale
Ceiling or Wall Bay Installation
1Run the speaker wire to the installation location. Be sure the wire meets electrical and building code requirements.
2Decide which of the wire inputs you want to use and remove the appropriate knockout cover(s). If the wiring will be “daisy chained” to other speaker, remove other knockout covers as needed. Snap a ULM connector into each of the knockouts removed.
3If you are using a 70/100 V constant voltage transformer, mount it on the mounting studs provided inside the FRB.
4Position the FRB unit between the rafters or studs. The mounting holes in the front plate align with common rafter/stud separation. Center the mounting screw holes over the rafter/stud and level the FRB.
5Fasten the FRB to the rafter/stud with at least 4 screws.
6Before installing the drywall, carefully measure the location of the FRB unit and cut the appropriate hole. The hole cutout diameter is listed in the specifications table.
7Connect the speaker (and the 70/100V transformer if it is used) and mount the speaker according to the instructions supplied with it.
4