Connecting the Speakers (Continued)
Push down on the top of the terminal to open the hole for the wire. Insert the wire and release the terminal to secure it. Be sure there are no loose strands of wire. Note: there is a channel in the back of the speaker for the wire (for wires up to 16 gauge), to keep it neat and out of sight.
Mounting the Speakers
1
Once you have the bracket mounted and the speaker connected the rest is easy.
1.Put the rounded end of the speaker mount in the bracket and slide it down to lock it in place.
2.Optional – Insert and tighten the screw to secure everything.
3.Snap the cover over the bracket.
2
Pivot Set Screw
3
The SoundWare speakers pivot on their mounts. Vertically they can go from |
|
|
facing straight out to being tilted down 40 degrees. When the flat wall mounting |
|
|
bracket is used they can pivot side to side 20 degrees. (Note: Corner mounting |
| pivots 20° |
will not allow the speaker to pivot |
| each way |
on the front of the pivoting ball mount, pivot the speaker into position and |
| |
|
| |
retighten the screw. |
|
|
|
|
pivots down 40°
Subwoofer Location
Place the subwoofer on the floor near the television.
Be careful to avoid obstructing the grille, where the sound comes out. Also, avoid placing the subwoofer in a position where curtains or blankets obstruct airflow around the rear panel.
OK
6
