Manuals / BOXLIGHT / Computer Equipment / Projector

BOXLIGHT CD-450m, CD-550m manual Usage Guidelines, If You Need Assistance, Warranty

Models: CD-450m CD-550m

1 70

Download 70 pages 51.72 Kb

Page 13

Usage Guidelines

•Do not look directly into the projection lens when the projector is turned on. The bright light may harm your eyes.

•Do not block the grills on the projector. Restricting the air flow can cause it to overheat and turn off. If this happens, you must wait a minute before attempting to turn it back on.

•Handle the projector as you would any product with glass components. Be especially careful not to drop it.

•Avoid leaving the projector in direct sunlight or extreme cold for extended periods of time. If this happens, allow it to reach room temperature before use.

•This projector is not intended for use in mainframe computer rooms as defined in the Standard for the Protection of Elec- tronic Computer/Data Processing Equipment, ANSI/NFPA 75.

•Transport the projector in a vendor-approved hard or soft case. Part numbers for these cases are listed on page 46.

If You Need Assistance

The first place to look for help is in this manual. Be sure to check the guidelines in “Troubleshooting” on page 39.

If this manual doesn’t answer your question, call Boxlight at 1-800-762-5757.

Warranty

This product is backed by a limited two-year warranty. The details of the warranty are printed at the back of this manual.

5

Image 13

BOXLIGHT CD-450m, CD-550m manual Usage Guidelines, If You Need Assistance, Warranty

Contents

USER’S GUIDE BOXLIGHT CD-450m/ CD-550m19332 Powder Hill Place Poulsbo, WA 98370-7407 USA Direct PhoneFCC Warning Safety CertificationsCanada EN 55022 WarningTrademarks Declaration of ConformityPage Safety Instructions TABLE OF CONTENTSSetting up the Projector Using the ProjectorIndex AppendixSpecifications AccessoriesWarning Hot surface. Do not touch SAFETY INSTRUCTIONSIf you need assistance, call Boxlight at INTRODUCTION Image ResolutionCD-450m CD-550mUnpacking the Projector Compatibilityanything is missing Shipping box contents Side view of projector I n t r o d u c t i o nFront view of projector speakerUsage Guidelines WarrantyIf You Need Assistance I n t r o d u c t i o n SETTING UP THE PROJECTOR S e t t i n g Connecting the CablePro III to the Projectort h e P r o j e c t o rEquipment you want to connect Preparing to Connect Your Equipment to the ProjectorPage If your computer has a PS/2 connector, use the PS/2 mouse cable Connecting a Laptop ComputerDo you want to play your computer’s audio on the projector? NOTE The USB mouse is sup- ported for use with Windows 98 only Connecting the CablePro audio and mouse cables to a laptop computeraudio cable mouse cable Connecting a Desktop Computer audio cable mouse cable monitor cable audio/video cable Connecting a Video PlayerS-video cable A/V cable Powering up the Projector and Adjusting the Image Turning Off the Projector Page Basic Image Adjustment USING THE PROJECTORUsing the Remote Control disk mouse right mouse button left mouse button Remote controlon underside of remote Adjusting the Projector Menu Using the Keypad and Remote ButtonsMouse buttons Source keypad onlyIf you don’t press standby again, the lamp turns off after 15 minutes Drop-down menu Using the On-Screen MenusDisplay Menu Color Reset AllBlank Screen Audio Menu Image Menu Horizontal position Manual TrackingVertical position NOTE The Manual Sync Manual Tracking, Horiz. PosiVideo Standard Controls MenuStandby Time Ceiling ProjectionRear Projection Default SourceAuto Source Select Plug and PlayDisplay Startup Screen Language MenuStatus Menu Indicates the active source, Computer or Video Cleaning the Lens MAINTENANCE & TROUBLESHOOTINGReplacing the Projection Lamp 5 Loosen the two non-removable screws on the outside of the module 4 Pull the lamp door up and remove itM a i n t e n a n c e T r o u b l e s h o o t i n g7 Remove the module Figure Sliding the lamp connectorRemoving the lamp module Replacing the Batteries in the Remote Control Troubleshooting Problem Nothing on projection screen Using the Kensington LockProblem The screen resolution is not right Problem Color or text not being projectedProblem Image isn’t centered on the screen Problem Only the start-up screen displaysProblem Image is out of focus Problem Image is too wide or narrow for screenProblem Image and menus are reversed left to right Problem the projector displays vertical lines, “bleeding” or spotsProblem Lamp seems to be getting dimmer Problem Image is “noisy” or streakedProblem Lamp shuts off Temperature APPENDIX SpecificationsDimensions WeightVideo Audio Input A p p e n d iComputer Audio Input Standard Accessories ship with the projector AccessoriesPower Cords one ships with projector, type depends on country NOTE Use only Boxlight approved accessories. Other prodA p p e n d i Optional AccessoriesPortable and Laptop Activation Chart Key command to Key command toA p p e n d i ComputerKey command to Key command toComputer activate portKey command to Key command toA p p e n d i ComputerKey command to Key command toComputer activate portUsing Video Mirroring with a PowerBook Computer NOTE Use these charts and tables to help you determine pro Projected Image Sizejected image sizes Image Size, Width and Height for CD-450m-maximum image sizeImage Size, Width and Height for CD-450m-minimum image size A p p e n d iDistance to DiagonalDistance to Image Size, Width and Height for CD-550m-maximum image sizeDiagonal WidthImage Size, Width and Height for CD-550m-minimum image size A p p e n d iDistance to DiagonalINDEX I n d e Page video mirroring on a PowerBook 52 video standards temperature limits 43 test patternVolume buttons 23 volume, adjusting 23 warrantyWARRANTY LIMITATION AND EXCLUSION LIMITED WARRANTYDISCLAIMER OF UNSTATED WARRANTIES LIMITATION OF LIABILITYPart Number