APPENDIX
LAMP REPLACEMENT INDICATOR
When the life of the Lamp of this projector draws to an end, the LAMP REPLACEMENT indicator lights red. When the image becomes dark or the color of the image become unnatural, replacement of the Lamp is required.
LAMP REPLACEMENT
CAUTION
● For continued safety, replace with a lamp assembly of the same type.
● Allow the projector to cool for at least 45 minutes before you open the lamp cover. The inside of the projector can become very hot.
●Do not drop the lamp assembly or touch the glass bulb! The glass can shatter and may cause injury.
Follow these steps to replace the lamp assembly.
1 | Turn off the projector and disconnect the AC plug. Allow the |
|
projector to cool for at least 45 minutes. |
| |
2 | Cover.Remove a screw with a screwdriver and remove the Lamp |
|
3 | Remove 2 screws with a screwdriver and pull out the Lamp |
|
Assembly by grasping the handle. |
| |
4 | Replace the Lamp Assembly with new one and tighten 2 | LAMP COVER |
| ||
screws. Make sure that the Lamp Assembly is set properly. | HANDLE | |
| And replace the Lamp Cover and tighten a screw. | |
5 | Connect the AC Power Cord to the projector and turn the |
|
projector on. |
| |
6 | Reset the Lamp Replacement Monitor Timer (refer to the |
|
section “Lamp Replacement Monitor Timer” below). |
|
NOTE : Do not reset the LAMP REPLACEMENT MONITOR
TIMER, when the lamp is not replaced. | LAMP | |
ASSEMBLY | ||
|
ORDER REPLACEMENT LAMP
Replacement Lamp can be ordered through Boxlight at
●Replacement Lamp Type No. :
(Service Parts No. 610 280 6939)
LAMP REPLACEMENT MONITOR TIMER
Be sure to reset the Lamp Replacement Monitor Timer when the Lamp Assembly is replaced. When the Lamp Replacement Monitor Timer is reset, the LAMP REPLACEMENT indicator stops lighting.
1 | Turn the projector on, and press the MENU button and the | |
| LEFT/RIGHT buttons to select SETTING | and press the SELECT button (refer to the page 40). Another |
| dialog box SETTING MENU will appear. |
|
2 | Press the POINT DOWN button and a | |
| SELECT button. The message "Lamp replace monitor Reset?" is displayed. | |
3 | Select [Yes] to reset the Timer. |
|
Do not reset the Lamp Replacement Monitor Timer, except after the lamp is replaced.
43
