APPENDIX
LAMP REPLACEMENT
If the lamp fails to come on and the lamp monitor on the projector light is orange, you must replace the lamp.
●For continued safety, replace with a lamp assembly of the same type.
● Allow the projector to cool for at least 45 minutes before you open the lamp cover. The inside of the projector can become very hot.
●Do not drop the lamp module or touch the glass bulb ! The glass can shatter and cause injury.
Follow these steps to replace the lamp assembly. |
| ||
1. | Turn off the projector and allow the projector to cool thoroughly. |
| |
2. | Disconnect the AC cord from the projector. |
| |
3. | Remove screw with a screwdriver and remove the lamp cover. |
| |
4. | Remove 2 screws with a screwdriver and pull out the lamp assembly by |
| |
| grasping the handle. |
| |
5. | Replace the lamp assembly. |
| |
6. | Tighten 3 screws to secure the lamp cover and the lamp assembly. |
| |
7. | Connect the detachable AC cord to the projector. | LAMP | |
8. | Reset the lamp replacement monitor timer. | ||
REPLACEMENT | |||
| (See "LAMP AGE" section on page 48.) | ||
| INDICATOR | ||
NOTE: Do not reset the LAMP REPLACEMENT MONITOR TIMER, except after the lamp is replaced.
LAMP
COVER
ORDER REPLACEMENT LAMP
LAMP
ASSEMBLY
HANDLE
Replacement Lamp can be ordered through Boxlight Corporation at
● Model No. of your projector | : BOXLIGHT |
●Replacement Lamp Type No. :
(Service Parts No. 610 282 2755)
50
