Names and functions of each part | BOXLIGHT MP-86i guide

Names and functions of each part (continued)

Remote control I/R receiver

Main power switch

Used to turn the power on and off.

:OFF

:ON

AC IN jack

Used to connect the accessory power cord.

Caution Connecting to the AC IN jack

Make sure the accesory power cord is plugged into the AC IN jack as far as it will go. Incomplete connection can result in fire or electrical shock.

VIDEO IN jack

S-VIDEO IN jack

Mini DIN 4-pin connector VIDEO IN jack

RCA jack AUDIO L/R IN jack RCA jack

1RGB IN2S-VIDEO IN

RGB IN jack

D-sub 15-pin shrink (1/2)

			VIDEO IN
	CONTROL		RGB OUT
CONTROL jack			AUDIO IN
CONTROL jack			L
D-sub 15-pin shrink			L
D-sub 15-pin shrink
			MONO
			R
AUDIO IN		AUDIO
1	2	OUT
			USB

	USB jack
AUDIO IN jack (RGB)	The mouse cursor can be controlled by
AUDIO IN jack (RGB)	remote control by connecting to a
Stereo mini jack	personal computer’s external mouse port.
	personal computer’s external mouse port.

AUDIO OUT jack (RGB/VIDEO)

Stereo mini jack

RGB OUT jack

D-sub 15-pin shrink

Page 9

Image 9

BOXLIGHT MP-86i user manual Names and functions of each part

Contents

Features ContentsOutline For the Customers in U.K Power cord Video signal cablesBefore Use Video inputs Do not install on an unstable surface If a problem should occurDo not look through the lens when the lamp is on Use only the indicated power supply Handle the power cord with care Do not position the powerDo not allow the laser beam to enter the eyes Battery usage Care and maintenanceClean the projector interior once every two years Avoid installation in humid or dusty locations Avoid excessively hot locations Sound volumeLens care Cabinet care Names and functions of each part Checking the package Contents Names and functions of each part Names and functions of each part Remote control transmitter 1Remove the battery cover 3Close the battery cover2Loading the batteries Typical LCD Projector and Screen Installation InstallationUsing the adjusters Top view Side view Turn on the power to the connected equipment Turn on the main power switch of the projector I onBasic operations To project Turn off the main power switch of the projector OFF Turning off the powerPlug & Play Press the STANDBY/ON button for approximately 1 second Cancelling the Freeze function Freeze functionPress the Freeze button Changing the magnification ratio Magnify functionMoving the display area Returning to normal display Adjustments and functions Returning to the initial settingsPress the Menu Using the Setup Menu SET UP Input Image OPT Connection to the RGB signal terminal Connection to the video signal terminalsInput signals Signal input jacks Example of computer signal Connection to the RGB signal terminal Initial set signals Connection to the RGB signal terminal Connecting the USB Mouse functions Connection to the control signal terminal Control signal jack Connection to the control signal terminal RS232C communication System Video Command data chart Requesting projector status Cleaning the Air filter Example of system setupPull out the power cord Remove the front air filter Install the air filter Clean the air filter with a vacuum cleanerLamp Message table Indicators Troubleshooting Dimensional Diagram Limited Warranty About the warranty and after-service QR41981

Names and functions of each part (continued)

VIDEO IN jack

AUDIO IN jack (RGB)