Hardware installation | MicroNet Technology SP3367A guide

2.4 Hardware installation

This section describes how to connect and configure the ADSL router.

1) Connect the ADSL line

Connect the router directly to the wall jack using the included ADSL RJ-11 telephone cable.

2) Connect a workstation to the Router's LAN port

Use Ethernet RJ-45 cable to connect computer or expend Ethernet network.

3) Connect the power adapter to the Router

Connect the power adapter to the port labeled POWER on the rear panel of router.

4) Connect all cables to the Network

The procedure for connecting cables differs depending on whether or not your telephone equipment is connected to a POTS splitter. The next section explains ADSL splitter and describes the configuration in networks of ADSL over POTS and ADSL over ISDN.

13

Image 14

MicroNet Technology SP3367A user manual Hardware installation

Contents

MicronetR CE Declaration of conformity FCC Part FCC Part Page Contents Device Info System Log Adsl Statistics Chapter Introduction Overview ATM Protocols FeaturesADSL2/2+ Compliance Wireless Features Bridge ModeRouter Mode Security Http Web-Based Management System RequirementsEthernet Interface Contents description InstallationChecklist Front LEDs Power Rear Ports Hardware installation Splitter Configuration Pots Splitter Configuration Adsl over Pots 1 Router connected through a Pots Splitter Isdn Splitter Configuration Adsl over Isdn 3 Router Connected through a Isdn Splitter Relative configuration on PC Determine connection settingsConnecting the Router to network ConnectionPage Page Configuration Access the Modem Router Quick Setup Page Page Page Internet Interface SetupATM VC Configuration WAN Configuration Page Page Page Dynamic Routing LAN Configuration Dhcp Relay DNS Wireless Settings Channel ID Wireless Security Advanced Setup Routing Table Static Routing NAT Setting DMZ Setting Virtual Server Adsl Firewall Access Management 1 ACL IP Filtering Snmp UPnP Ddns Maintenance Administration Time Zone Firmware Update System Restart Diagnostic Status Device Info WAN System Log Adsl Statistics Troubleshooting Steps Corrective Action Cannot access the web management Steps Corrective Action Forget my login username and/or password Initialization of the Adsl connection failed Bridge Appendix a GlossaryAddress mask Broadband Dynamic IP Addresses Dhcp Dynamic Host Configuration ProtocolDownstream rate Encapsulation Http Hop countHtml browser Internet address IP address PPPoE Router Remote serverRoute Routing table Subnet SpoofingStatic IP Addresses Telnet UNI signaling Virtual Connection VC Appendix B Cabling Straight-through vs. Crossover Cables LAN Connection Appendix C Service / Port Service Name, Protocol and Port number