MicroNet Technology SP3367A manual

Bridge: Bridge mode is a common connection method used for xDSL

modem.

29

Image 30

MicroNet Technology SP3367A user manual

Contents

MicronetR CE Declaration of conformity FCC Part FCC Part Page Contents Device Info System Log Adsl Statistics Chapter Introduction Overview Features ADSL2/2+ ComplianceATM Protocols Wireless Features Bridge ModeRouter Mode Security System Requirements Ethernet InterfaceHttp Web-Based Management Installation ChecklistContents description Front LEDs Power Rear Ports Hardware installation Splitter Configuration Pots Splitter Configuration Adsl over Pots 1 Router connected through a Pots Splitter Isdn Splitter Configuration Adsl over Isdn 3 Router Connected through a Isdn Splitter Relative configuration on PC Determine connection settingsConnecting the Router to network ConnectionPage Page Configuration Access the Modem Router Quick Setup Page Page Page Interface Setup ATM VC ConfigurationInternet WAN Configuration Page Page Page Dynamic Routing LAN Configuration Dhcp Relay DNS Wireless Settings Channel ID Wireless Security Advanced Setup Routing Table Static Routing NAT Setting DMZ Setting Virtual Server Adsl Firewall Access Management 1 ACL IP Filtering Snmp UPnP Ddns Maintenance Administration Time Zone Firmware Update System Restart Diagnostic Status Device Info WAN System Log Adsl Statistics Troubleshooting Steps Corrective Action Cannot access the web management Steps Corrective Action Forget my login username and/or password Initialization of the Adsl connection failed Bridge Appendix a GlossaryAddress mask Broadband Dynamic IP Addresses Dhcp Dynamic Host Configuration ProtocolDownstream rate Encapsulation Http Hop countHtml browser Internet address IP address PPPoE Router Remote serverRoute Routing table Subnet SpoofingStatic IP Addresses Telnet UNI signaling Virtual Connection VC Appendix B Cabling Straight-through vs. Crossover Cables LAN Connection Appendix C Service / Port Service Name, Protocol and Port number