To turn off the power, Plug&Play, Standby mode | BOXLIGHT MP-93i

Basic operations (continued)

To turn off the power

3

2

1	1	STANDBY/ON	MUTE
	1
		FREEZE
STANDBY/ON		MAGNIFY VOLUME
		OFF
	INPUT
MUTE		POSITION ON	LASER

MENU

RESET

RESET	RIGHT
MENU ON	MOUSE ON
BLANK	TIMER
RGB	VIDEO
	INPUT

ENGLISH

	1	Press the STANDBY/ON button, for 1 second.
		• The ON indicator blinks orange and the lamp turns off. (About 1 minute later), the fan stops and
		the indicator lights up orange.
		• Press the STANDBY/ON button for short time (less than 1 second), the projector do not set in
		standby mode.

	2	Turn the MAIN POWER switch of the projector off.[ : OFF]

	3	Install the lens cap.

	Caution		• To reduce temperature inside the projector, fan will rotate for about 1 minute after the lamp
			is turned off.

•Do not turn off the MAIN POWER switch during the lamp on because the lamp is damaged.

PLUG&PLAY

This projector complies with VESA DDC1/2B specifications. PLUG&PLAY is a system with computer, peripherals (including projectors), and operating system.

It works when the projector is connected to DDC (Display Data Channel) ready computer that is running an operating system software that incorporates plug & play functionality.

(Only RGB 1)

13

Image 13

BOXLIGHT MP-93i specifications To turn off the power, Plug&Play, Indicator lights up orange, Standby mode, Is turned off

Contents

Contents FeaturesOutline Operating Guide For the Customers in U.K Power cord Video signal cablesBefore use Instructions to Users Do not install this unit in an unstable place Do not look directly at the lens when Lamp is litDo not use power supplies other Than that specified If any abnormality occurs Cleaning Be careful in handling the power cordHandle the power cord carefully Do not step on this unit or do not put a Heavy object on it Clean inside the unit at least once two years When you are not going to use For a long timeDo not place this unit where it gets hot Volume Names and functions of each part Contents of shipping box AC in socket Remote control sensor Main Power switchVideo input terminal RGB input terminal Remote control transmitter Remove the battery compartment cover How to insert batteries Example of the projector and screen installation InstallationHow to use foot adjusters To project the picture Basic operations Indicator lights up orange To turn off the powerStandby mode PLUG&PLAY Magnifying Function Freeze Function To return to the initial setting Adjustments and functionsMemory function On-screen menus are displayed on the screen How to use the SET UP menu SET UPAdjustment Item Details of adjustment Freeze Magnify Manual Operation AUTO-adjustment Confirm Screen AUTO-adjustmentDuring AUTO-adjustment Adjustment Item Details of adjustment OPT ImageMenu Image serves of the picture inversion Menu OPT. allows you to control communication function etc Connection to the RGB signal terminal Connection to the video signal terminals Resolution Standard Display Dots KHz Type Example of computer signal Computer/signal Horizontal Timing µs Initial set signalsComputer/signal Vertical Timing lines Pin No RS-232C Mouse PS/2 Control signal terminalSerial +5V ADB Mac mouse PS/2 mouseSerial mouse Control command table Control command tableCommunication RS232C cable Reference Control data table Procedure of setting the Projector status Procedure of getting the Projector statusProcedure of default setting the Projector status Example of command error Connecting various equipment Example of system setupAC Inlet Computer Note type ComputerDesk type Air filter Filter cover Cleaning the air filterDo not use with removed air filter Remove the lamp cover How to replace lampLoosen two screws and pull the handle to remove Lamp Reset the lamp time Install the lamp cover and fix it using screwsLamp Message table Blink in the following cases Indicator display All dimensions shown in inches Dimension diagramRCA Jack terminal Input terminal Input/Output RCA Jack terminal Terminal