Express® Deck Lavatory System EXD-Series

 

EXD-2N

Installation Instructions

Installation Instructions

Supplies required for installation:

(6) 3/8" wall anchors, bolts and 1" min. O.D. washers to mount main frame and bowl to wall (minimum pull-out rating of 1,000 lbs.)

STD. HEIGHT ONLY: (2) 3/8" wall anchors, bolts and 1" min. O.D. washers to mount scuff base to wall

1/2" NPT hot and cold supply piping

1-1/2" NPT drain piping

110 volt electrical outlet for optional 110/24 VAC plug-in transformer, if required

(2) #10 wall anchors and fasteners for optional Vernatherm™ valve mounting

240/208-volt or 277-volt electrical box for optional electric tankless water heater

Step 1: Rough in

IMPORTANT: Dimensions shown in Figure 1 on page 5 are for a Standard and Wall- Hung Pedestal Express® Deck only. Make sure to follow appropriate dimensions based on configuration and required rim height. See Charts 1 and 2 on page 5 before beginning rough-ins.

1.Rough in 1/2" NPT hot and cold supply lines through wall at dimensions shown.

2.Rough in 1-1/2" NPT drain waste connection through wall at dimensions shown.

3.FOR OPTIONAL ELECTRIC FAUCETS: Install the 110 volt GFCI electrical outlet per local code at the location shown in Figure 1.

4.Install four to six 3/8" wall anchors with a minimum pull-out rating of 1,000 lbs. (supplied by installer) at the locations shown in Figure 1.

5.On the back of the bowl, measure the distance between the 3/4" bowl mounting holes. Divide this measurement in half. Measure and mark this dimension on the wall to the left of the centerline and to the right of the centerline. Install two 3/8" wall anchors with a minimum pull- out rating of 1,000 lbs. (supplied by installer) at the locations marked (ref. location “A” shown in Figure 1).

NOTE: Wall anchors at location “C” (standard frame only) do not require a minimum pull-out rating of 1,000 lbs.

NOTE: The anchors will be used to mount the Express® Deck bowl and frame to the wall.

4

2/9/07

Bradley Corporation • 215-1542 Rev. E; EN 06-915

Page 4
Image 4
Bradley Smoker EXD-2N installation instructions Installation Instructions, Supplies required for installation, Rough