Bradley Smoker EXD-2N Mounting frame to wall, Procedure #3 on page 4 Figure

Express® Deck Lavatory System EXD-Series
EXD-2N	Installation Instructions

Installation Instructions continued . . .

Step 2: Mounting frame to wall

1.Using a T20 Torx key, remove the six #10-24 flat head Torx screws and #10 finish washers securing the access panel to the main frame, and remove the panel (Figure 2).

2.Position the frame against the wall, ensuring that it is level.

IMPORTANT: Anchoring the frame to a wall that is not flat may cause the frame to

bend, making it difficult to reinstall the access panels.

3.Ensure that the back of the frame is flat against the wall.

4.Once you have positioned the

frame such that it is level (and	MAIN FRAME
resting on the floor, standard height
frame only) and flat against the
wall, use the 3/8" bolts and 1" min.	ACCESS PANEL
O.D. washers to mount the frame
to the wall (Figure 3).
5. When mounting the standard	#10-24 PANEL FASTENERS
height frame, mount the scuff base	AND WASHERS
	(6) PLACES
to the wall at the same time using
the two additional 3/8" bolts and	SCUFF PANEL
washers mentioned in Step 1,	STANDARD HEIGHT
	FRAME ONLY
procedure #3 on page 4 (Figure 3).	SCUFF PANEL FASTENERS
	AND WASHERS
	(4) PLACES
	Figure 2

*

*

3/8" WALL ANCHORS

(4) PLACES

MAIN FRAME

*

*

*

*

Figure 3

SCUFF BASE FRAME STANDARD HEIGHT FRAME ONLY

3/8" WALL ANCHORS

(2)PLACES

STANDARD HEIGHT

FRAME ONLY

6 2/9/07 Bradley Corporation • 215-1542 Rev. E; EN 06-915