Bradley Smoker EXD-2N installation instructions Installing bowl

	Express® Deck Lavatory System EXD-Series
Installation Instructions	EXD-2N

Installation Instructions continued . . .

Step 3: Installing bowl

WARNING: To prevent serious injury and/or damage to the bowl, move and position the bowl with the assistance of another person and always use appropriate lifting procedures.

NOTE: Refer to Figure 4 below when installing the bowl.

1.With someone to assist you, place the bowl squarely onto the frame.

2.Attach the front underside of the bowl to the frame using the two 1/4"-20 x 1/2" pan-head screws and washers provided. Do not tighten bolts at this time.

IMPORTANT: When bolting the bowl to the frame and wall, do not overtighten bolts. Overtightening bolts can damage the Terreon® material.

3.After the bowl is attached to the frame, use 3/8" bolts and 1" min. O.D. washers (supplied by the installer) to bolt the bowl to the wall anchors, two places.

4.Tighten the screws installed in procedure #2 above to secure the bowl to the frame. Do not overtighten.

Figure 4

BOWL

1/4-20 SCREWS AND WASHERS

(2)PLACES BOWL/FRAME MOUNTING

MAIN FRAME

3/8" BOLT AND WASHER	SCUFF BASE FRAME
	AND DRAIN ASSEMBLY
(2) PLACES FOR
	NOT SHOWN FOR CLARITY
BOWL MOUNTING

Bradley Corporation • 215-1542 Rev. E; EN 06-915 2/9/07 7