Bradley Smoker SS-3 Connecting plastic tubing, Installation Instructions continued

Express® Lavatory System SS-Series
SS-3/AST/WH97TAS	Installation Instructions - For Service Only

Installation Instructions continued . . .

Step 5: Connecting plastic tubing

NOTE: Refer to Figure 7a for hot and cold supplies, and refer to Figure 7b for tempered supply.

1.Connect the plastic tubing for the water supplies from the sprayhead assembly to the quick- connect fittings on the air valve as follows:

•insert the tubing with the red marking to the left valve

•insert the tubing with the black marking to the middle valve

• insert the tubing with the green marking to the right valve

IMPORTANT: The plastic tubing for the water supplies and pushbuttons are pre-cut to the correct lengths. If the tubing is cut too short, kinking can occur and cause leaks at the fitting locations.

2.Connect the plastic tubing for the pushbuttons from the sprayhead assembly to the quick-connect fittings on the air valve as follows:

•insert the tubing with the red marking to the left valve

•insert the tubing with the black marking to the middle valve

•insert the tubing with the green marking to the right valve

3.Assemble the P-trap (supplied) and make drain connections.

AIR TUBING

AIR TUBING

(BLACK)

(GREEN)

WATER SUPPLY

(BLACK)

AIR TUBING

(RED)

WATER

WATER SUPPLY

SUPPLY

(RED)

(GREEN)

AIR VALVE

FLEXIBLE

VERNATHERM™

SUPPLY

MIXING VALVE

Figure 7a

HOSES

AIR TUBING

FLEXIBLE

(BLACK)

SUPPLY

HOSE

WATER SUPPLY

AIR TUBING

(BLACK)

(GREEN)

AIR TUBING

(RED)

WATER SUPPLY

WATER

(RED)

SUPPLY

(GREEN)

AIR VALVE

Figure 7b

10 5/11/04 Bradley Corporation • 215-1240 Rev. D; EN 03-813