Printer-Applicator-System PAM 300042
Code Printout Code Printout Code Printout Code Printout
DEC HEX DEC HEX DEC HEX DEC HEX
00 00 08 08 16 10 24 18
01 01 09 09 17 11 25 19
02 02 10 0A 18 12 26 1A
03 03 11 0B 19 13 27 1B
04 04 12 0C 20 14 28 1C
05 05 13 0D 21 15 29 1D
06 06 14 0E 22 16 30 1E
07 07 15 0F 23 17 31 1F
12 Monitor Mode / ASCII Dump Mode
If programming directly, the monitor mode provides a method to print control sequences which
were received at the interface. The commands will be printed in text format depending on the
selected character set. Error messages will be printed directly behind the fault, e.g. for
unknown commands.
NOTICE !
In monitor mode, the printer will not recognize gaps between labels nor control
the ribbon feed.
For questions or future reference, print and retain one copy of the label format for each label
printed.

Start of Monitor Mode/ ASCII Dump Mode

To start the monitor mode, press the key while switching on the printer, and keep it
pressed down until the system test is completed. The display shows "ASCII Dump Mode".
Following send a print job to the printer and then press the pre-dispense key to print out the
contents of the label.
In monitor mode, the print of data will be started after every four lines of data received.
Therefore, in some cases, the last lines of the label have to be retrieved by pressing the
key.
To cancel ASCII Dump mode, press the key.

Representation of the Control Characters

The control characters (ASCII Code 00 ... 31) as shown in monitor mode printouts are as
follows.
Table 12 Representation of the control characters in monitor mode