Braun 6021 manual Memory mode, Changing the temperature scale

Memory mode

The last temperature taken before the Braun ThermoScan is turned off is stored in its memory and will be automatically displayed when it is turned on again. The display will show «MEM». For longer display of the stored measurement, the thermometer must be turned on and the «I/O» button must be pressed for at least 1 second. The memory mode is left automatically after pressing the «I/O» button for at least 1 second.

Changing the temperature scale

Your Braun ThermoScan is shipped with the Fahrenheit temperature scale activated. If you wish to switch to Celsius «°C», proceed as follows:

		Make sure the thermometer is turned off.
		Press and hold down the «I/O» button. After about
		3 seconds the display will show this sequence:
		«°F» / «SET» / «°C» / «SET» ...
...	...	Release the «I/O» button when «°C» is shown.
		There will be a short beep to confirm the new setting,
		then the thermometer is turned off automatically.
		When turned on again, temperatures will be shown
		in Celsius, until the above procedure is repeated.

Base station for storage, charging, anti-theft function (optional)

For your Braun ThermoScan PRO 4000, there is a Base Station available. Contact your distributor for details (see page 14).

The station automatically recharges the thermometer (when using the rechargeable batteries supplied with the base station), and it has an electronic, individually adjustable anti-theft function. It also serves as a convenient storage base (can be wall mounted).

It requires returning the thermometer to the station within an individually pre-selected time. Otherwise the thermometer will be locked.

When leaving the factory, the anti-theft function of the PRO 4000 is turned off.

If the anti-theft function is enabled, and when not in the measuring process (stand-by mode) the thermo- meter will show the hours remaining before it is locked.

To turn on the anti-theft function, please refer to the base station manual.

8