Description

1Special cord set

2«start cleaning» button

3Station-to-shaver connecting contacts

4Station lift button for cartridge exchange

5Display for cleaning programs

6Display for cleaning fluid status

7Station mains socket

8Cleaning cartridge

9Shaver foil protection cap

10Shaver foil

11Cutter block

12Foil release buttons

13Long hair trimmer

14Shaver-to-station connecting contacts (shaver backside)

15Switch

16Shaver charging lights (green)

17Shaver low-charge light (red)

18Replacement light for shaving parts

19Reset button

20Pilot light

21Shaver mains socket

Before shaving

If you wish, you may start shaving right away (if the shaver is charged, see section «The shaver indicator lights»). However, we recommend to follow the procedure described here:

Using the special cord set (1), connect the socket of the Clean&Renew™ station (7) to an electrical outlet.

Press the station lift button (4) to open the housing.

Hold the cleaning cartridge (8) down on a flat, stable surface (e.g. table).

Carefully remove the lid from the cartridge.

Slide the cartridge into the base of the station as far as it will go.

Slowly close the housing by pushing it down until it locks.

eco normal intensive

cartridge

full

 

empty

1

2

7

Page 7
Image 7
Braun 8986 manual Description, Before shaving