Jura Capresso Guide to Using Capresso Cleaning Solution for Your Coffeemaker

Important: Do NOT fill this funnel with instant coffee and do not use more than two level scoops of coffee.

•Touch one of the three cup symbols to select cup size and then touch ST@RT. While brewing, the display shows (for example) BIG CUP POWDER.

Please note: When using pre-ground coffee, you cannot use the 1-Cup or 2-Cup button.

Please note: If you push the scoop button accidentally, touch ST@RT to clear. The F9 starts the brewing process, and stops after a few seconds. The display will return to SELECT PRODUCT. Please note: After use of sugar coated or flavored coffee through the pre-ground coffee funnel you may experience some flavor transfer when going back to your regular coffee. Push the Rinse Button (Fig. 3b) once or twice to process some water through the coffee spouts.

12. USING HOT WATER

With the Hot Water Button (Fig. 4a) you can make a cup of tea, a quick soup or add hot water to your coffee, making it less strong. Caution: Always make sure that you have a container under- neath the frother (Fig. 15) when using the hot water function, otherwise hot water might splatter, causing severe injuries.

•Push the Hot Water Button WATER PORTION. Hot water will flow immediately out of the frother.

•To stop the water flow, push the Hot Water Button again. Please note: The hot water portion is set to approx. 5 oz. It can be programmed from 1 to 16 oz. (chapter 18f).

13. FROTHING, STEAMING AND HEATING

The steam function can be used to heat up any liquid and to steam and froth milk.

Steaming Position:

The metal cylinder is in the UP position (Fig. 18). In the steaming position hot steam is injected into the milk (or any other liquid) without creating a frothy layer on top.

Frothing Position:

The metal cylinder is in the DOWN position (Fig. 18). In the froth- ing position hot steam and air is injected into the milk creating warm milk and a firm layer of tiny froth bubbles.

14. HEATING AND FROTHING MILK

•Fill a pitcher (10 to 12 oz. capacity) or a large cup with at least 4 to 5 oz. of cold milk.

•Push the Steam Button (Fig. 4b). The Steam Button's red light will start blinking and the display reads YOUR MACHINE IS HEATING. After a few seconds the red light stays illuminated and the display reads SELECT PRODUCT.

•Immerse the tip of the frother into the milk and push the Steam Button again (Fig. 4b). Hot steam will be injected into the milk. During this time the display shows STEAM PORTION.

•To stop the steam function, push the Steam Button again. Please note: Steam output will automatically stop after 60 sec- onds. If you need more steam just push the Steam Button again and you will have another 60 seconds of steam. You can also change the steam output to a shorter interval (chapter 18e).

Tips for frothing (Cappuccino):

Start in the steaming position (cylinder "up") for 10 to 20 sec- onds. This way your milk will be warmed up first. Then push the cylinder "down". Milk froth will build up. This way the froth on top of your milk is also warm. If the frothed milk is not warm enough, continue in the steaming position.

14.