Jura Capresso 63942R warranty Water Portion Insert Filter, Filter Rinsing, Your Machine Is Heating

The machine beeps and the display shows:

WATER PORTION INSERT FILTER

•Place a large container underneath the frother (at least 30 oz.)

•Push the Hot Water Button. The machine pumps water through the frother, activating the new filter. This will take about 90 seconds. During this time the display shows:

FILTER RINSING.

When the water flow stops the displays shows:

YOUR MACHINE IS HEATING

The machine automatically returns to the coffee brewing mode:

SELECT PRODUCT

17. ADJUSTING THE WATER HARDNESS

Important: If the Claris Cartridge is activated (see chapter 16a) this chapter does not apply.

The water is heated inside the machine. With use, this leads to calcium deposits forming inside the machine. The display will remind you when it is time to perform a decalcifying cycle. The machine is set to level 2 (medium hard water). If you have hard- er water you need to set it to a higher level. If you have softer water you can set it to level 1. If you are not sure about the hardness of your water, ask your local water company for the "Water Hardness in Grains."

HARDNESS LEVEL 1: grains 2-9

HARDNESS LEVEL 2: grains 10-19

HARDNESS LEVEL 3: grains 20-29

HARDNESS LEVEL 4: grains 30+

You can also use the enclosed water hardness indicator strip to determine the water hardness:

•Insert the stick for one second into the water you want to use. Shake off any access water and wait for one minute.

•If all five fields of the test stick turn reddish, set the hardness level to 4. If four fields turn reddish, set the hardness level to 3. If three or less fields turn reddish, leave the level in position 2.

You can change the hardness settings as follows:

SELECT PRODUCT

•Push and hold the P button (Fig. 3e) until you hear a beep. The display will show two red arrows and FILTER NO.

•Touch the right hand arrow once and the display shows:

HARDNESS LEVEL 2.

•Touch ST@RT until you hear a beep. The 2 starts blinking.

•Touch the left or right arrow until the desired number appears: 1, 2, 3, 4 or –.

•Touch ST@RT to confirm. The number stops blinking.

•Push the P button to return to SELECT PRODUCT Important: If you choose the selection "–" the water hardness monitor is turned off. In this case the machine will NOT remind you when it is time to decalcify. Turning off the monitor requires you to use distilled water only or the Claris Filter (chapter 16a). If you use regular or bottled water the machine will build up cal- cium. If calcium build-up inside the machine is not removed, it can lead to a complete machine break down.

18. PROGRAMMING

Please note: As long as you are in programming mode, you cannot brew coffee.

You can change a variety of functions. To get into programming mode press and hold the P button (Fig. 3e). You will hear a beep

17.