Voltage Trigger
The BA-200 is capable of being triggered to turn on using the input labeled Control. The BA-200 is designed to respond to any incoming voltage of 3 - 30 volts. Many audio components have a voltage output for this purpose. The connection is easily made using a mono cable with a 3.5 mm mini connection on both ends. A voltage trigger cable is supplied with the package. This is plugged into the voltage trigger output on the source component and into the voltage input on the BA-200. The BreatheAudio Elevate Audio Distribution System has an output labeled Control for use with the BA-200, fig. 3. By using the voltage trigger, the BA-200 power switch can be left in the on position and triggered to turn on and off automatically by the presence of a voltage from the audio source equipment.
Fig. 3
| SPEAKER |
OUTPUT POWER |
| 8 OHM: 70W X 2 |
| 4 OHM: 100W X 2 |
| LEFT | RIGHT |
- | + - | + |
USE ONLY WITH 250V FUSE
INTE RTEK | | |
CM | | CONFORMS |
| | TO |
C | US | UL STD. |
3033118 | |
| |
| MODEL BA-2430 | |
| Two Source Four Zone | |
| Whole Home Music System | |
120V | 60Hz 150W | FUSE:T2AL 250V | |
www.breatheaudio.com | Cincinnati Ohio USA | |
IR OUT | OUTPUT | INTE RTEK |
| | | CM |
38KHz | 56KHz | C | US |
| |
| 1 | | 3033118 |
| CONTROL | |
WARNING: TO REDUCE THE RISK
OF FIRE OR ELECTRIC SHOCK.
2AUDIO
| | | | | THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. |
| | | | | OPERATION IS SUBJECTED TO FOLLOWING TWO CONDITIONS: |
NORMAL | USE FOR SAT | | | | (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE,AND |
| | |
USE | OR CABLE | | | | (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, |
| | | INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. |
| | | | | | |
Speaker Output
The BA-200 provides 100 watts output per channel at 4 ohms and is stable down to 2 ohms. This allows it to provide an audio signal to multiple pairs of speakers in a large area. It uses a modular plug that will accept up to 14-gauge, two or four-conductor speaker wire, however 16-gauge wire is recommended. The proper polarity is Left negative, Left positive, Right negative, and Right positive, fig. 4.
Fig. 4
LEFT LEFT RIGHT RIGHT
- + - +